-
Purge Controls
purge-controls
-
Model 9016: FM Approved X-Purge Control Systems
FM approved X-purge control system for Division 1 environments. X-purge designed for use on customer supplied enclosure.
Division 1, X-Purge Control, Stand-Alone
Features:
- Microprocessor controlled purge with self-diagnostics
- Short purge time
- Full set of AC and I/O signal interlocks
- Complete with solenoids, air-in gauge, regulator, outlet valve and spark arrestor.
- No assembly required, easy to install.
- Low internal operating pressure (4″ water column).
- Can be used on enclosures from 1 cubic foot to 30 cubic feet in size.
- Environmentally and financially friendly – Only uses compressed air when internal pressure drops below preset level.
- Automatic self-adjusting microprocessor controlled purge system with self diagnostics.
- Interface box mounts externally on any of the enclosure’s six walls, eliminating use of additional internal enclosure space.
- Compact design can be mounted vertically, horizontally, or flush.
- No additional parts required.
-
Model 9017: Z-Purge Control System
Z-purge control system is Factory Mutual Approved for Division 2 environments. Z-purge designed with built-in vent value with spark arrestor and built-in flow meter and pressure gauge for easy setup and operations on customer supplied enclosure.
Division 2, Z-Purge Control
Features:
- Short purge time
- Built-in vent value with spark arrestor
- Built-in flow meter and pressure gauge
- Pre-assembled for easy installation
- Low internal pressure
- Suitable for enclosure from 1 cubic foot to 50 cubic feet in size
- Short purge time (less than 2 minutes per cubic foot)
-
Conduit Seal and Air Connection Kits
A conduit seal kit that prevents explosive vapors from traveling through conduit into purge cabinet and purge air from the enclosure traveling into customer-installed conduit. The corresponding air connection kit helps provide regulated, instrument grade clean and dry air/inert gas required for purge applications. Conduit Seal Kit
Features:
Conduit Seal Kit- Helps install single, ridged schedule 40 conduit for power or signal lines to Daisy Data’s 9016 Series X Purge control or purged enclosure.
- Includes conduit seal fitting, fiber packaging, seal compound, plastic bottle applicator brush, face mask and measure
- Contents include, conduit seal fitting, fiber packing, sealing compound, plastic bottle, applicator brush, face mask and measure.
- Meets or exceeds all local electrical codes and NFPA requirements when installing ridged conduit in a hazardous area.
- Prevents explosive vapors from traveling through conduit into the purge cabinet and purge air from the enclosure traveling into customer-installed conduit.
- For installation of 1/4” pressurized or compressed air line to Daisy Data’s purge control device.
- Includes air regulator, air dryer, line filter, pressure gauge and shut off valve.
- Helps you provide regulated, instrument grade, clean and dry air/inert gas, required for purge applications.